110KHz Ultrasonic Transducer Sonar Sensor Transducer for Ultrasonic Fish Finder

    110KHz Ultrasonic Transducer Sonar Sensor Transducer for Ultrasonic Fish Finder

Technical parameters:

Block diagram of ultrasonic transducer :

Schematic Diagram of Temperature Sensor (model: MF58_502F3470):


Integrated type Cable instruction:   

1.Wiring instruction of transducer: interface (3pin, 2.54mm terminal)
Red: transducer +      
White: transducer -         
Black: shielding


2.Cable Instruction of Temperature Sensor: interface (3pin, 2.0mm terminal)

Red and black are temperature sensor wiring

Split type: standard 10m cable, with each additional 50m of cable, the signal attenuation is 6dB

Three-core wiring instructions:                
                        
    Red: Transducer +
     Blue: temperature sensor +
     Black: Public-

 Four-core wiring instructions:

Red: Transducer +                      
Yellow: Transducer-
Blue, black: temperature sensor

Fish Finder Ultrasonic Sonar Sensor

A fish finder consists of two parts: main unit (with a screen) and transducer. The main unit should be located where it can be easily accessed in the cabin or wheelhouse, etc. The transducer should be mounted on the boat's bottom either through hull or in-hull installation. Please bear in mind that the performance of a fish finder depends largely on whether the transducer is properly mounted on the boat's bottom. An improperly mounted transducer may result in failure in capturing reflected waves or other serious defects. To avoid these troubles, you should consult with a technical dealer on how to properly install the transducer prior to actual installation.