Titanium-housed Ultrasonic Transducer Sensor for Ultrasonic Gases Flowmeters

Product Description

Titanium-housed Ultrasonic Transducer Sensor for Ultrasonic Gases Flowmeters

Parameters:

Items	Technical Parameters		Image
Name	200KHz ultrasonic transducer
Model	PHA-200-01X
Explosive gas atmospheres	Work normally
Active zone diameter	15 mm
Frequency	200KHz±5%
Recommended range	0.10～1.5m
Minimum Parallel lmpedance	360Ω±20％
Capacitance	500pF±20％ @1KHz
Sensitivity	Driving Voltage：800Vpp，Distance:0.6m， Echo Amplitude：40mV
Operating voltage	Peak Voltage＜1000 VPP
Operating Temperature	-40～+80℃
Pressure	16Kilos or 1.6MPa
Usage	(Beamwidth) Half-power Beam Width@-3dB:7°±2， Sharp Angle:18°±4
Housing Material	titanium alloy
Application	Ultrasonic Gas Flow Meter
Installation Dimension	customized according to customer’s requirements
Protection Level	IP68
Weight	20g±5％（ Length：20cm）
Wiring Instructions	Integrated interface：Red+，White-，Black: shielded wire （ default : without temperature sensor）
Admittance Curve		Product Structure Diagram

Block diagram of ultrasonic transducer :

Schematic Diagram of Temperature Sensor:

Integrated type Cable instruction:

1.Wiring instruction of transducer: interface (3pin, 2.54mm terminal)

Red: transducer +

White: transducer -

Black: shielding

2.Cable Instruction of Temperature Sensor: interface (3pin, 2.0mm terminal)

Red and black are temperature sensor wiring

Ultrasonic Gas Flow Meters Application:

Although industrial gas flow meters are widely utilised for liquid and water applications, it has long been accepted that clamp on gas flowmeter technology could not be applied to mass gas flow measurement primarily due to fundamental theoretical measurement limits. In fact only 4.9 x10-7 percent of the transmitted sound energy is received by traditional ultrasonic transducers. However, advances in clamp on gas flow measurement technology and processing have meant that despite lower acoustic impedance levels and higher attenuation levels in most gases, a clamp on gas flow meter can now measure transit times in gases where signal-to-noise ratios are extremely low. It is now possible to measure natural gas, steam, compressed air, hydrogen, compressed air and many more using clamp on flow meters.

Titanium-housed Ultrasonic Transducer Sensor for Ultrasonic Gases Flowmeters

Product Description

Related Products