105KHz Ultrasonic Transducer Distance for Ultrasonic Level Measurement
Product Description
Low Cost 105KHz Ultrasonic Transducer for Anemorumbometer
Technical parameters：
Items |
Technical Parameters |
Image |
|
Name |
105KHz ultrasonic transducer C type |
|
|
Model |
PHA-105-03C |
||
Frequency |
105KHz±5% |
||
Detection Distance |
0.15～3m |
||
Minimum Parallel lmpedance |
540Ω±20％ |
||
1200pF±20％ @1KHz |
|||
Sensitivity |
Driving Voltage：750Vpp，Distance:0.3m， Echo Amplitude：150mV |
||
-40～+80℃ |
|||
≤3Kilos or 0.3MPa |
|||
|
(Beamwidth) Half-power Beam Width@-3dB:9.1°±2， Sharp Angle:21.7°±4 |
||
Housing Material |
LY12 |
||
Usage |
Ultrasonic level gauge，ultrasonic transducer，anemorumbometer ，ultrasonic gas flow meter |
||
Check the structure diagram below |
|||
Protection Level |
IP68 |
||
Weight |
50g±5％（Length：2m） |
||
Wiring Instructions |
integrated type：connector：Red+，White-，Black: shielded wire； ( temp sensor is optional) |
||
Admittance Curve |
Product Structure Diagram |
||
|
|
||
Block diagram of ultrasonic transducer :
Schematic Diagram of Temperature Sensor:
Integrated type Cable instruction: :
1.Wiring instruction of transducer: interface (3pin, 2.54mm terminal)
Red: transducer +
White: transducer -
Black: shielding
2.Cable Instruction of Temperature Sensor: interface (3pin, 2.0mm terminal)
Red and black are temperature sensor wiring
Application of Ultrasonic level measurement:
Continuous level measurement in liquids and solids with ultrasonic level sensors
Ultrasonic level measurement with Prosonic sensors provides continuous, non-contact and maintenance-free level measurement of fluids, pastes, sludges and powdery to coarse bulk materials. The measurement is unaffected by dielectric constant, density or humidity and also unaffected by build-up due to the self-cleaning effect of the sensors. Check out the broad range of Prosonic devices for ultrasonic level measurement and click on the button below.