11 Beam Topographic And Geomorphic Scanning Transducer Ultrasonic Transducer for Ultrasonic Flowmeter
Product Description
11 Beam Topographic And Geomorphic Scanning Transducer Ultrasonic Transducer for Ultrasonic Flowmeter
Technical parameters:
Items |
Technical Parameters |
Image |
|
Name |
11 Beam topographic and geomorphic scanning transducer |
|
|
Model |
PHW-200-11D |
||
Frequency |
200KHz±5% |
||
Detection Distance |
0.6~120m |
||
Minimum Parallel lmpedance |
Ω±20％ |
||
pF±20％ @1KHz |
|||
Sensitivity |
|||
-40～+80℃ |
|||
≤10Kilos or 1MPa |
|||
|
(Beamwidth)Half-power Beam Width@-3dB: °±10%， Sharp Angle : °±10% |
||
Housing Material |
POM |
||
Usage |
Ultrasonic flowmeter, underwater rangefinder |
||
See the product structure drawing |
|||
Protection Level |
IP68 |
||
Weight |
|||
Wiring Instructions |
Red+，White-，Black: shielded wire； （temperature sensor is optional） |
||
Admittance Curve |
Product Structure Diagram |
||
Block diagram of ultrasonic transducer :
Schematic Diagram of Temperature Sensor (model: MF58_502F3470):
Integrated type Cable instruction:
1.Wiring instruction of transducer: interface (3pin, 2.54mm terminal)
Red: transducer +
White: transducer -
Black: shielding
2.Cable Instruction of Temperature Sensor: interface (3pin, 2.0mm terminal)
Red and black are temperature sensor wiring
Split type: standard 10m cable, with each additional 50m of cable, the signal attenuation is 6dB
Three-core wiring instructions:
Red: Transducer +
Blue: temperature sensor +
Black: Public-
Four-core wiring instructions:
Red: Transducer +
Yellow: Transducer-
Blue, black: temperature sensor